Ans:A
26.A network designed to attenuate certain
frequencies and allow other to pass without attenuation is called
A.Filter
B.Attenuator
C.Low noise amplifier
D.Pre-Amplifier
Ans:A
27.The instrument used to display a signal in frequency domain is
A.CRO
B.Wave Analyser
C.Spectrum Analyser
D.DSO
Ans:C
28.IC 7447 is
A.Encoder IC
B.Comparator IC
C.Mulitplexer IC
D.Decoder IC
Ans:D
29.The element used to separate transmitting and receiving signals in a single
antenna system.
A.Detector
B.Mixer
C.Low Noise Amplifier
D.Duplexer
Ans:D
30.Which one is not an internal part of PLC?
A.CPU
B.Timer
C.Communication interface
D.DIMM
Ans:D
31.In an SCR Holding current is
A.Equal to latching current
B.Less than Latching current
C.Greater than Latching current
D.Zero
Ans:B
32.The synchronous speed of a synchronous motor is
directly proportional to
A.Number of poles
B.Applied voltage
C.Frequency of input voltage
D.None of these
Ans:C
33.Bandwidth of an FM radio station
A.250 KHz
B.175 KHz
C.200 KHz
D.10.5 KHz
Ans:C
34.Number of Flip Flips required to construct a
MOD12 counter
A.12
B.6
C.4
D.3
Ans:C
35.The IC 8279 is
A.DMA controller
B.PPI
C.Interrupt controller
D.Keyboard and Display Interface
Ans:D
36.Which logic family has the lowest propagation
delay?
A.Standard TTL
B.RTL
C.HTL
D.Schottky TTL
Ans:D
37.Anti-fuse is related to
A.SCR
B.SRAM
C.ASIC
D.MOSFET
Ans:C
38.---------is not a microprocessor.
A.8088
B.8086
C.Z80
D.8051
Ans:D
39.What is the total power of an AM signal with 100
Watts carrier power and 100% depth of modulation?
A.100 watts
B.100 K watts
C.150 watts
D.150 K watts
Ans:C
40.Foster-Seeley demodulator is
A.AM Demodulator
B.FM Demodulator
C.PAM Demodulator
D.PPM Demodulator
Ans:B
41.SCR in reverse blocking mode,the junctions are
reverse biased are
A.J1 alone
B.J2 and J3
C.J2 Alone
D.J1 and J3
Ans:D
42.Snubber circuits are used in SCR circuit for
A.To limit current
B.To protect from high dv/dt.
C.Protect from over temperature
D.None of these
Ans:B
43.Which oscillator that can be fabricated in IC
form?
A.Relaxation Oscillator
B.Crystal Oscillator
C.RC Phase Shift Oscillator
D.Wein Bridge Oscillator
Ans:A
44.Base of a number system is also called
A.Count
B.Radix
C.Value
D.Nibble
Ans:B
45.Divide by error interrupt in 8086 can initiated
using
A.RST 0
B.By Resetting
C.Using INTR
D.INT 0
Ans:D
46.Using three numbers of
resistances----------number of combinations can be made.
A.3
B.4
C.5
D.2
Ans:B
47.The ideal output resistance of a voltage
amplifier is------------resistance.
A.Unity
B.Infinity
C.1000
D.Zero
Ans:D
48.CMRR is related to
A.Inverter
B.Chopper
C.Amplifier
D.Op-Amp
Ans:D
49.Capacity of a single layer Blu-ray disc
A.5.5 GB
B.11 GB
C.25 GB
D.50 GB
Ans:C
50.Nyquist sampling theorem is related to
A.BPSK
B.PPM
C.PCM
D.FDM
Ans:C
51.The ideal data speed of 5 G mobile network
A.20 GB/s
B.5 GB/s
C.1 GB/s
D.22.5 GB/s
Ans:A
52.The type of connector used in telephones
A.RJ-45
B.RJ-11
C.RJ-10
D.RJ-9
Ans:B
53.Signals transmitted over several different paths
is called
A.Multi-user diversity
B.Time diversity
C.Space diversity
D.None of these
Ans:C
54.The light detector used in optical fibre
communication
A.PIN Diode
B.APD
C.(1)and (2)
D.None
Ans:C
55.Class C amplifiers are commonly used
as-------Amplifiers.
A.AF current
B.AF voltage
C.Radio frequency
D.Pulse amplifier
Ans:C
56.The number of select lines in a 1 to 8
de-multiplexer is
A.2
B.3
C.4
D.8
Ans:B
57.Number of address lines required to address a
memory system made of 2 modules of 1 MB memory chips
A.12
B.20
C.21
D.None of these
Ans:C
58.A Karnaugh Map is an abstract form of
----------diagram.
A.Cycle diagram
B.Block diagram
C.Logical diagram
D.Venn diagram
Ans:D
59.A logic circuit that has memory is
A.Sequential circuit
B.Combinational circuit
C.Both(1)and (2)
D.None of these
Ans:A
60.The basic block in an HDL program is called
A.Object
B.Gate
C.Module
D.Model instantiation
Ans:C
61.Number of bits in a Binary Coded Decimal Number
A.8
B.4
C.2
D.1
Ans:B
62.All Keywords in c programming is
A.Lower case
B.Upper case
C.Both upper and lower cases
D.Digits only
Ans:A
63.In the specifications of a network interface card
10/100 stands for
A.Length of Media
B.Mega bits per second
C.Protocol
D.None of these
Ans:B
64.Ripple factor of Halfwave rectifier is
A.1.21
B.0.482
C.40.6
D.81.2
Ans:A
65.Major application of a Var-actor diode is
A.Rectifier
B.Voltage doubler
C.Demodulator
D.Tuning circuit
Ans:D
66.Cut-in voltage of Germanium diode is
A.0.2 V
B.0.6 V
C.1.0 V
D.0.7 V
Ans:A
67.Which of the following has highest internal resistance?
A.A constant current source
B.A constant voltage source
C.Both of these
D.None of these
Ans:A
68.A DC current source has a short circuit current
of 4 mA and an open-circuit voltage of 20 V.The internal resistance is
A.5 KU
B.100 U
C.4 KU
D.100 KU
Ans:A
69.The overall gain of RC coupled amplifier is small
due to
A.Large bandwidth
B.Loading effect of successive stages
C.Impedance of capacitor
D.None of these
Ans:B
70.Intrinsic standoff ratio is the charcteristics of
A.Semi-conductor
B.Tunnel diode
C.FET
D.UJT
Ans:D
71.Stability of a circuit increases with
A.Positive feedback
B.Negative feedback
C.Current series feedback
D.Both(1)and (2)
Ans:B
72.An emitter follower is
A.Current series feedback circuit
B.Voltage series feedback circuit
C.Both(1)and (2)
D.None of these
Ans:A
73.The output frequency of a crystal oscillator is
stable because of
A.High Q of the crystal
B.Low XL/R Ratio
C.Rigid Crystal Structure
D.Small size
Ans:A
74.An Ideal Op-Amp has
A.Zero output resistance
B.Infinite Voltage gain
C.Infinite input impedance
D.All of these
Ans:D
75.An example for wave shaping circuit is
A.Astable Multi-vibrator
B.RC Relaxation oscillator
C.Schmitti Trigger
D.None of these
Ans:C
76.Number of diodes in a bridge rectifier is
A.2
B.4
C.1
D.None of these
Ans:B
77.Bucking voltage is another name for
A.Back emf
B.Breakdown voltage
C.Saturation voltage
D.Knee voltage
Ans:A
78.The gain of amplifier in RC phase shift
oscillator should be
A.180
B.1
C.28
D.29
Ans:D
79.In a PTC thermistor,the temperature at which
resistance increases rapidly is known as
A.Temperature coefficient
B.Switching point
C.Break point
D.Valley point
Ans:B
80.Forbidden energy gap of Germanium is
A.0.72 eV
B.1.12 eV
C.1.1 eV
D.2.1 eV
Ans:A
81.Esaki diode is another name for
A.Schottky Diode
B.PIN Diode
C.Tunnel Diode
D.DIAC
Ans:C
82.In a signed binary number,the sign used to
indicate a negative number is
A.0
B.1
C.00
D.None of these
Ans:B
83.Which one is a serial to parallel converter?
A.Decoder
B.Multiplexer
C.De-Multiplexer
D.Both(1)and (2)
Ans:C
84.Number of modes of operations in TRIAC
A.4
B.2
C.5
D.1
Ans:A
85.Which one is not a networking component?
A.RS 232
B.NIC
C.Router
D.Bridge
Ans:A
86.How many bytes of bits addressable locations are
present in 8051 microcontroller?
A.20
B.16
C.8
D.32
Ans:B
87.Instruction queue size in 8086 is-------bytes.
A.6
B.8
C.12
D.16
Ans:A
88.Number of transistors integrated in 8086
microprocessor
A.32000
B.29000
C.20000
D.64000
Ans:B
89.Inelastic scattering of photon is defined by
A.Hall effect
B.Miller effect
C.Multiple scattering
D.Raman effect
Ans:D
90.Rise time budget is related to
A.Microwave link
B.RF link
C.Optical link
D.None of these
Ans:C
91.Johnson-Nyquist noise is another name
for----------noise.
A.Short noise
B.Flicker noise
C.Transit time noise
D.Thermal noise
Ans:D
92.According to--------a spatially varying electric
field is always associated with a magnetic field that changes over time.
A.Lens law
B.Faraday’s law
C.Flemings LH law
D.Maxwells equations
Ans:D
93.A hollow conductive metal pipe used for
communication is called
A.Microwave link
B.Wave Guide
C.Duct
D.OFC
Ans:B
94.Which one is not an embedded operation system?
A.Android
B.WebOS
C.iOS
D.Solaris
Ans:D
95.The first Personal Computer(PC)was introduced by
A.IBM
B.Intel
C.Microsoft
D.Sun Microsystems
Ans:A
96.IEEE 802.11 is the standard used for
A.GSM
B.CDMA
C.Ethernet
D.WLAN
Ans:D
97.The point of intersection of DC and AC load lines
is called
A.Saturation point
B.Cut-off point
C.Operating point
D.Peak point
Ans:C
98.A zener diode that has very narrow depletion
layer will breakdown by ---------mechanism.
A.Zener breakdown
B.Avalanche breakdown
C.Both(1)and (2)
D.None of these
Ans:A
99.In a multivibrator,we have -------feedback.
A.Negative feedback
B.50% positive feedback
C.100% positive feedback
D.None of these
Ans:C
100.For display of signal pattern---------voltage is
applied to the horizontal plates of a CRO.
A.Sinusoidal
B.Saw tooth
C.Triangular
D.Rectangular
Ans:B
The only thing that stands between you and your dream is the will to try and the belief that it is actually possible.-Joel Brown.
ReplyDelete